[Mich VHF UHF Society] beacon signal report

[Harvey Hamel]

kf6a completely below noise level except for an occasional dot or dash out
of noise. Opps QSB caused KF6A ot just come out of noise for a few seconds


N2CB

Harv

On Sat, Jun 20, 2015 at 6:14 PM, Rich Anderson <richwa8mti at gmail.com> wrote:

> Dan, q5 s0 on my PAR omni loop@ 18' in EN62xx
> Rich, WA8MTI
> On Jun 20, 2015 5:11 PM, "Dano" <blown4.6 at gmail.com> wrote:
>
>> Hello all.
>>
>> I built a 6m half-wave loop and installed it on a temporary pole at 20ft.
>> I am curious to see whether it can be heard so if you could please listen
>> to 50.081 CW and email me a signal report I would be very thankful.
>>
>> The SWR curve and frequency of low SWR is almost spot on what was
>> predicted by EZNEC, but since it isn't a beam I cannot turn it to find
>> nulls and see if the pattern is also as predicted. Don't worry, this is
>> only temporary for testing purposes. I do not plan on putting up a 6m
>> propagation beacon.
>>
>> I'll leave it in beacon mode for the next few hours unless there is a 6m
>> opening to EU/AF, etc. then I'll turn it off and chase some DX. :-)
>>
>>
>> Thank you in advance for your time.
>>
>>
>> 73,
>>
>> Dan KF6A...
>>
>> _______________________________________________
>> MiVUS mailing list
>> MiVUS at mivus.org
>> subscribe/unsubscribe
>> http://mail.mivus.org/mailman/listinfo/mivus_mivus.org
>>
>>
> _______________________________________________
> MiVUS mailing list
> MiVUS at mivus.org
> subscribe/unsubscribe
> http://mail.mivus.org/mailman/listinfo/mivus_mivus.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.mivus.org/pipermail/mivus_mivus.org/attachments/20150620/776468a6/attachment.htm>