<div dir="ltr"><div class="gmail_default" style="font-size:xx-large">I am running my IC 7300 with a switching psu - an Alinco DM-30T which has a noise offset control which works very well and allows me to dial out any switch mode noise that comes from the power supply. This unit seems to be very clean in that regard and I seldom need to adjust the noise filter, and it cost me about $135.00 so I think for your needs (probably way over the amp requirements) I would get one of these Alincos with the noise offset circuit.  </div><div><div dir="ltr" class="gmail_signature" data-smartmail="gmail_signature"><div dir="ltr"><div style="font-size:xx-large"><span></span><span></span>73,</div><div style="font-size:xx-large">Steve~W8SFC </div></div></div></div><br></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Tue, 7 Apr 2020 at 15:13, Patrick Thomas <<a href="mailto:p-thomas@mindspring.com">p-thomas@mindspring.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">Hi all,<br>
<br>
Some of you might recall that I had a 222 beacon on the air for a while... which I took down due to a couple of problems... mostly the ~1khz drift, and also some HF QRM, presumably from mixing with the switching power supply.<br>
<br>
I had been meaning to move to a newer (digitally synthesized, different mode) type of beacon anyway, and finally have gotten to a point where I am on the right track... hopefully will be putting the GPSDO and OCXO boards together this week while on "vacation" from work so I'm hoping it will be back on the air very soon.<br>
<br>
The downside is that the power out from the RF stages is very low.  I have found a surplus Motorola 220 radio which has a PA section I believe I can borrow which will boost it to the ~15W range, which is "about right" I would say.<br>
<br>
Buuut... I also am really concerned about the noise issues from before, especially if using an amplifier, as I would like to get away with a switched power supply but I know there will also be a lot of noise due to the microelectronics.  Can someone suggest an appropriate type of filter that might be appropriate here?  I know a cheap-and-dirty high pass is customary, but I am wondering if this might dictate something a little more exotic, particularly as it will run "unattended" for some time.  I would also think some filtering after the PA may be appropriate, though this doesn't seem to be especially common.<br>
<br>
What do y'all think, in this case?<br>
<br>
Thanks,<br>
<br>
Pat<br>
KB8DGC<br>
<br>
_______________________________________________<br>
MiVUS mailing list<br>
<a href="mailto:MiVUS@mivus.org" target="_blank">MiVUS@mivus.org</a><br>
subscribe/unsubscribe <a href="http://mail.mivus.org/mailman/listinfo/mivus_mivus.org" rel="noreferrer" target="_blank">http://mail.mivus.org/mailman/listinfo/mivus_mivus.org</a><br>
</blockquote></div>