<html><head></head><body><div class="ydp2615f97yahoo-style-wrap" style="font-family:Helvetica Neue, Helvetica, Arial, sans-serif;font-size:16px;"><div><div>Hi Chuck,</div><div><br></div><div>I measure low levels of power with a HP 432A power meter.  But it will measure power down to only -20dBm.  That's useful for low transmit power.</div><div><br></div><div>But how about using another receiver to check your signal source?  The S meter on my Flex 6500 is supposedly very well calibrated, and it reads out directly in dBm.  An empty antenna port on the Flex reads -113 dBm.  That would at least verify your signal source.  <span><span style="color: rgb(0, 0, 0); font-family: Helvetica Neue, Helvetica, Arial, sans-serif; font-size: 16px;">Problem is, I live in Grand Rapids...</span></span></div><div><br></div><div>If you're not super concerned about accuracy, I'd just use any known good receiver to check your signal source.  I attached a typical S meter chart to dBm chart I copied from Wikipedia.</div><div class="ydp2615f97signature"><div style="font-family:Helvetica, Arial, sans-serif;font-size:16px;"><p> </p><div><p style="color:rgb(0, 0, 0);font-family:Helvetica, Arial, sans-serif;font-size:16px;">Dave DeVos - KF8QL</p><div style="color:rgb(0, 0, 0);font-family:Helvetica, Arial, sans-serif;font-size:16px;">Retired guy cell is 616-278-8068</div></div><br><p></p></div></div></div>
        <div><br></div><div><br></div>
        
        </div><div id="ydp5e115863yahoo_quoted_1838811603" class="ydp5e115863yahoo_quoted">
            <div style="font-family:'Helvetica Neue', Helvetica, Arial, sans-serif;font-size:13px;color:#26282a;">
                
                <div>
                    On Friday, June 21, 2019, 05:18:08 PM EDT, Chuck MacCluer <maccluer13@gmail.com> wrote:
                </div>
                <div><br></div>
                <div><br></div>
                <div><div id="ydp5e115863yiv3145543367"><div>Before I take a Teamviewer session from Moscow to diagnose my SunSDR2's lack of gain on 2m, I need to verify the output of my Elecraft XG3 signal source at 144 MHz. <div><br></div><div>Does anyone near to me have the equipment to verify the three levels of -- 107, -- 73, and -- 33 dBm?</div><div><br></div><div>I am just east of Lansing and could drive a hour or so to you.</div><div><br></div><div>Chuck w8mqw</div></div></div>_______________________________________________<br>MiVUS mailing list<br><a href="mailto:MiVUS@mivus.org" rel="nofollow" target="_blank">MiVUS@mivus.org</a><br>subscribe/unsubscribe <a href="http://mail.mivus.org/mailman/listinfo/mivus_mivus.org" rel="nofollow" target="_blank">http://mail.mivus.org/mailman/listinfo/mivus_mivus.org</a><br></div>
            </div>
        </div></body></html>